128
- FCC Regulatory Information
Regulatory Information/Disclaimers
Installation and use of this Wireless LAN device must be in strict accordance with the instructions included in the
user documentation provided with the product. Any changes or modifications made to this device that are not
expressly approved by the manufacturer may void the user’s authority to operate the equipment. The manufacturer
is not responsible for any radio or television interference caused by unauthorized modification of this device, or the
substitution or attachment of connecting cables and equipment other than those specified by the manufacturer. It is
the responsibility of the user to correct any interference caused by such unauthorized modification, substitution or
attachment. The manufacturer and its authorized resellers or distributors will assume no liability for any damage or
violation of government regulations arising from failure to comply with these guidelines.
Federal Communications Commission statement
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause interference, and, (2) This
device must accept any interference, including interference that may cause undesired operation of this device.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the
following measures:
1
Reorient or relocate the receiving antenna.
2
Increase the distance between the equipment and the receiver.
3
Connect the equipment to an outlet on a circuit different from the one the receiver is connected to.
4
Consult the dealer or an experienced radio/TV technician for help.
Figure A-1. Ad Hoc Mode Network