Fujitsu LifeBook P1000 User Manual Download

Page: 88 / 100

L i f e B o o k P 1 0 0 0 N o t e b o o k – A p p e n d i x

Table 10: Setting parameters

8. When you finish your entry, click [OK]. [Wireless

Network Connection 2 Properties] appears again.

9. Make sure the network name you specified for the

SSID in Step 7 is added under [Preferred networks].

Network Connection

The section describes how to set the network connection
for a computer running Windows XP.

Network Settings

In this section, you set “TCP/IP Settings,” and complete
“Checking Computer Name and Workgroup” required
for the network connection.

TCP/IP Settings

1. On [Wireless Network Connection Properties], click

[General].

2. Perform the following steps.

■

Click [Internet Protocol (TCP/IP)].

■

Click [Properties]. [Internet Protocol (TCP/IP)
Properties] appears.

3. Set an IP address. Ask your network administrator

and check the setting.

Table 11: Setting an IP address

5. Click [OK].

6. Close [Network Connection].

Checking the Full Computer Name and Workgroup

1. Click [Start] -> [Control Panel]. Make sure the

Classic View is selected.

2. Double-click the [System] icon. [System Properties]

appears.

3. Click the [Computer Name] tab.

4. Check [Full computer name] and [Workgroup]. Ask

your network administrator and check the setting.

Table 12: Setting computer name and workgroup

Hexa-
decimal
characters

Select this when using
hexadecimal characters for
the Network Key.

Use this if there is a wireless
LAN card in the network
that has the Network Key
set to a character code. In
’Network Key’, input the
same value as the other
wireless LAN card.

P O I N T

If [Wireless Network Connection 2 Properties] is not
displayed, click [Start] -> [Settings] -> [Control Panel],
and double-click the [Network Connection] icon.

Right click the [Wireless Network Connection], and
then click [Properties] from the menu that appears.

Item

Description

Item

Description

AdHoc
Network

Set the IP address and subnet mask.
Click [Use the following IP address].
Enter a value for [IP address] and
[Subnet mask]. See “Setting IP
Addresses” on page 87 to set IP
address and subnet mask.

For
Infrastructure
Network

Select [Obtain an IP address
automatically]. For the DNS server,
select [Obtain DNS server address
automatically]. For the IP address,
DNS server, and default gateway,
follow the network administrator's
instructions, if any.

P O I N T

If you have changed the setting, [Close] is shown
instead. Click [Close].

Item

Description

Computer
Name

A name to identify the computer on
the network. You can specify any
name to each computer. Use up to 15
single-byte characters. For easier
identification, use the model name or
user name.

Workgroup

A name of the network group. Use up
to 15 single-byte characters.

AdHoc Network:

Specify the same

name to all computers within the
same network.

Infrastructure Network:

Specify workgroup name to connect
to.

B5FH-6611-01EN-00.book Page 80 Thursday, September 26, 2002 11:21 AM