Working with the notebook
Calibrating the pen
Before using the pen for the
fi
rst time, you should calibrate it so that the cursor follows the
movements of the pen as accurately as possible. You should also always repeat the calibration
if the co-ordination between the pen and cursor movement deteriorates.
Operating system
Menu
Windows 7
To calibrate, call up the
Hardware and Sound / Tablet PC Settings
function
in the Control Panel. You need to calibrate both portrait and landscape
formats.
Replacing the pen tip
With use, the pen tip may become worn or may pick up foreign particles that can scratch the screen.
A damaged or worn tip may not move freely, causing unpredictable results when using the pen.
If your pen exhibits these problems, you should replace the pen tip. To do this, use the supplied tool (1).
1
►
To remove the tip, position the tip in the gap
between the two ends of the tool supplied.
►
Pinch the two ends of the supplied tool
together so that the tip is
fi
rmly clasped,
then pull it from the barrel.
►
To replace the tip, retrieve one of the
new tips that were supplied your pen.
Insert the
fl
at end of the tip into the
barrel and exerting gentle pressure, push
it in until it is
fi
rmly in place.
If the tip is worn or damaged, discard it.
Installing a pen cord
You should attach the pen with a pen cord to prevent accidentally dropping or losing it.
►
Attach the end of the pen cord with the smaller loop to your pen.
►
Attach the end of the pen cord with the larger loop to your notebook.
Fujitsu
37
