Manufacturer’s notes
Déclaration d’Industrie Canada
Cet appareil est conforme à la Section 15 des Règles de la FCC et à la (aux) norme(s) RSS
concernant les appareils exempt s de licence par Industrie Canada. Son fonctionnement est
soumis aux deux condition s suivantes : (1) cet appareil ne doit pas causer d’interférence
nuisible; (2) cet appareil doit accepter toutes les interférences reçues, y compris celles
pouvant causer un mauvais fonctionnement de l’appareil.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy. If not installed and used in accordance with
the instructions, it may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try and
correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the distance between the equipment and the receiver.
3. Connect the equipment to an outlet on a circuit different from the one the receiver is connected to.
4. Consult the dealer or an experienced radio/TV technician for help.
FCC Radio Frequency Exposure statement
The available scienti
fi
c evidence does not show that any health problems are associated with
using low power wireless devices. There is no proof, however, that these low power wireless
devices are absolutely safe. Low power wireless devices emit low levels of radio frequency
energy (RF) in the microwave range while being used. Whereas high levels of RF can produce
health effects (by heating tissue), exposure to low-level RF that does not produce heating
effects causes no known adverse health effects. Many studies of low-level RF exposure have
not found any biological effects. Some studies have suggested that some biological effects
might occur, but such
fi
ndings have not been con
fi
rmed by additional research.
The exposure standard for wireless devices employs a unit of measurement known as the Speci
fi
c
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg, and 1.6W/kg by Industry Canada.
This device is compliant with SAR for general population / uncontrolled exposure limits in
ANSI/IEEE C95.1-1992 and Canada RSS 102, and had been tested in accordance with
the measurement methods and procedures speci
fi
ed in FCC CFR Rule Part 15.247 and
15.401, and Canada RSS 102. This device has been tested, and meets the FCC, IC RF
exposure guidelines when tested with the device operating conditions.
Fujitsu
77
