Sense Data Error Recovery Methods
5 - 12
C141-E167
END
status received ?
BUS FREE
error ?
Timeout ?
See item (3).
See item (4).
GOOD
BUSY
QUEUE
FULL
Yes
Yes
Yes
Yes
No
No
No
No
Normal end
To item (1)
To item (1)
To item (2)
Yes
Yes
No
No
Yes
Command issue
PRESERVATION
CONFLICT
Issue of REQUEST
SENSE command
To Section 4.3.2
Figure 5.3
Analysis of the termination status
(1)
BUSY/QUEUE FULL status
This status indicates that the IDD is currently executing processing of another command and that a
new command cannot be received. The INIT that receives this status can reissue the original
command.
Under a multi-initiator environment, when an INIT receives this status, the time until the IDD can
receive the next command depends on the operating state with other INITs, so ordinarily, it cannot
be predicted. In such a case, it is necessary for the INIT that issued the command for which this
status was received to repeatedly issue the command until it is accepted.
To Section 5.3.2
Summary of Contents for MAP3147NC - Enterprise - Hard Drive
