37
3.1 Operating Setting Switches
■
Procedure for Changing a Parameter
The following procedure describes how to change a parameter.
1. After parameters are displayed, press the up and down keys to move the cursor (blinking) to
the digit (position) that you want to change.
2. Press the ENTER key to accept the digit (position) to be changed. At this time, the cursor
becomes an underscore (_).
3. Press the up and down keys to increment and decrement, respectively, the digit value
(value) until the desired one is displayed.
4. Press the ENTER key to accept the new value (value).
5. After accepting all new values (values), press the up and down keys to move the cursor to
the right of [OK], press the ENTER key, and exit the parameter change operation.
■
Methods for Selecting and Checking
Methods for selecting and checking are described below.
•
For selection: Use the Up or Down key to move the cursor to the location immediately to the
right of an item or command (e.g., [Yes] or [No]) to select the item or command, and click the
ENTER key.
•
For confirmation: Move the cursor to the location immediately to the right of [OK], and click
the ENTER key.
Summary of Contents for MB2147-01
