346
CHAPTER 16 DTP/EXTERNAL INTERRUPTS
16.3
DTP/External Interrupt
The interrupt related to the DTP/external interrupt occurs when the edge or level input
to input pin is detected.
The DTP/external interrupt can activate the DMA transfer and extended intelligent I/O
service (EI
2
OS).
■
DTP/External Interrupt
The interrupt control bit and interrupt source of the DTP/external interrupt is shown in the
following table.
❍
Setting procedure
To use the DTP/external interrupt, set each register by using the following procedures:
1. Set the interrupt request enable bit corresponding to the DTP/external interrupt channel to be
used to "0" (ENIR:EN).
2. Use the detection condition select bit corresponding to the DTP/external interrupt channel to
be used to set the edge or level to be detected (ELVR:LA/LB).
3. Set the interrupt request flag corresponding to the DTP/external interrupt channel to be used
to "0" (EIRR:ER).
4. Set the corresponding interrupt request enable bit to "1" (ENIR:EN).
Notes:
• When setting the registers for the DTP/external interrupt, the external interrupt request must be
disabled (ENIR:EN=0).
• When enabling the DTP/external interrupt (ENIR:EN=1), the corresponding DTP/external
interrupt request flag bit must be cleared in advance (EIRR:ER=0). These actions prevent the
mistaken interrupt request from occurring when setting the register.
External interrupt
When ISE of ICR = 0
DTP interrupt when ISE
of ICR = 1
Interrupt request flag
EIRR:ER (bit8 to 15)
EIRR:ER (bit8 to 15)
Interrupt request output enable bit
ENIR:EN (bit0 to 7)
ENIR:EN (bit0 to 7)
Interrupt generation source
Detect external interrupt
Detect external interrupt
Summary of Contents for MB90480 Series
