Important notes
•
The device may only be operated in wide format (0° landscape mode) and high format
(90° portrait mode). The buttons of the control panel are located at the bottom in
the middle of the monitor in wide format (0° landscape mode) and at the left-hand
side of the monitor in high format (90° portrait mode).
•
Store this manual close to the device. If you pass the device on to third
parties, you should pass this manual on with it.
•
We recommend that you place your device on a durable, non-slip surface. In view
of the many different
fi
nishes and varnishes used on furniture, it is possible that the
feet of the device may mark the surface they stand on.
•
The device must be connected to protective earth.
•
To prevent possible hearing damage, do not listen at high volume levels for long periods.
•
Warning for excessive sound pressure from earphones and headphones:
Excessive sound pressure from earphones and headphones can cause hearing loss.
Adjustment of the equalizer to maximum increases the earphones and headphones
output voltage and therefore the sound pressure level.
Power cable
Use the supplied power cable only.
Use the following guidelines if it is necessary to replace the original cable set.
•
The female/male receptacles of the cord set must meet IEC60320/CEE-22 requirements.
•
The cable has to be HAR-certi
fi
ed or VDE-certi
fi
ed. The mark HAR or
VDE will appear on the outer sheath.
•
For devices which are mounted on a desk or table, type SVT or SJT cable sets may be
used. For devices which sit on the
fl
oor, only SJT type cable sets may be used.
•
The cable set must be selected according to the rated current for your device.
•
If necessary, replace the original power cable with a regular grounded 3-core mains lead.
Transporting the device
Device,
Transportation
Retransportation
Transport all parts separately in their original packaging or in a packaging which
protects them from knocks and jolts, to the new site.
Do not unpack them until all transportation manoeuvres are completed.
If the device is brought from a cold environment into the room where it will be used,
condensation may occur. Before operating the device, wait until it is absolutely dry
and has reached approximately the same temperature as the installation site.
8
Fujitsu
Summary of Contents for P24-8 TE Pro
Page 1: ...Display Operating Manual FUJITSU Display P24 8 TE Pro ...
Page 3: ......