1.
Create the LinkAggregation Group
-
Solaris 10 8/07 or later
The following example shows how to create the LinkAggregation Group with the fjgi0, fjgi1 and fjgi2 interfaces and "key=1":
# /usr/sbin/dladm create-aggr -d fjgi0 -d fjgi1 -d fjgi2 1
-
Solaris 11
The following example shows how to create the LinkAggregation Group with the fjgi0(this vanity name is net2), fjgi1(this
vanity name is net3) and fjgi2(this vanity name is net4) interfaces and "aggr-link=aggr1":
# /usr/sbin/dladm create-aggr -l net2 -l net3 -l net4 aggr1
2.
Activate the LinkAggregation Group
-
Solaris 10 8/07 or later
-
The following example shows how to activate the "key=1" LinkAggregation Group and start the LinkAggregation (*1).
("IP address=192.168.150.1" is assigned to the representative interface "aggr1".):
# ifconfig aggr1 plumb 192.168.150.1 up
*1: After rebooting the system, the representative interface aggr1 is not activated.
-
The following example shows how to setup the "key=1" LinkAggregation Group for activation after rebooting the system.
("IP address=192.168.150.1" is assigned to the representative interface "aggr1".):
- 44 -
Summary of Contents for PCI Gigabit Ethernet
