Appendix F Using FUJITSU PCI GigabitEthernet in Solaris
11 Network Virtualization
This Appendix outlines the supported functions and setup procedure for the FUJITSU PCI GigabitEthernet 5.0 or later interface when
used in Solaris 11 Network Virtualization.
F.1 Solaris 11 Network Virtualization Support
The FUJITSU PCI GigabitEthernet 5.0 or later driver support the following features in Solaris 11 Network Virtualization.
-
VNIC by dladm(1M) command
-
Flow by flowadm(1M) command
F.2 Solaris 11 Network Virtualization Setup Procedure
Setup Solaris 11 Network Virtualization. For more information about Solaris 11 Network Virtualization, please refer to "System
Administration Guide: Network Interfaces and Network Virtualization" and "man pages section 1M:System Administration Commands"
of Oracle Documentation.
The examples below show the setting methods of VNIC (virtual network interface) and flows.
-
The following example shows how to create a VNIC (dladm create-vnic)
dladm create-vnic -l link vnic-link (link: physical link,
vnic-link: link name of VNIC)
- 76 -
Summary of Contents for PCI Gigabit Ethernet
