SVmco User Guidel
6
Required/
As
needed
Setting item
Automatic
setting (*1)/
Manual
setting (*2)
See
Setting the
management LAN
IP address
Manual
setting
2.1.5 Setting the
management
LAN IP address
Setting the
destinations of
traps from a
partition
Manual
setting
2.1.6 Setting the
destinations of
traps from a
partition
Configuring SNMP
to use duplicate
disks
Manual
setting
2.1.7
Configuring
SNMP to use
duplicate disks
Installing a SVmco
update
Not
applicable
2.1.8 Installing a
SVmco update
As
needed
Uninstalling
SVmco (*3)
Not
applicable
2.1.9
Uninstalling
SVmco
*1 Automatic setting: Values are automatically set during SVmco installation.
You may need to change an automatically set value. See the section listed in the
table.
*2 Manual setting: Values are not automatically set during SVmco installation.
Make settings as described in the section referred to in the table.
*3 To operate the PRIMEQUEST 1000x2 series server, you need to first install
SVmco
. If you uninstall SVmco, the following restrictions apply.
Even under an REMCS agreement, no software errors are reported.
