SVmco User Guide
217
If you change the MMB IP address or the management LAN IP address
on the partition, be sure to then restart SVmco. Otherwise, SVmco would
not be able to post any detected errors.
Notes on configuring Windows Server 2008
Do not stop the Windows Print Spooler service. The information
collection function of the operating system uses WMI (Windows
Management Instrumentation). If the Print Spooler service is stopped, the
function cannot collect the correct configuration information because WMI
reports an error.
If the set value of the following registry key is less than 20000 (20
seconds), the system may hang during operating system shutdown. Be
sure to set a value equal to or greater than 20000 (20 seconds).
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control
" WaitToKillServiceTimeout" (Type: REG_DWORD / default;
20000)
You can use the above registry key to specify the wait time (ms) before
the service is terminated in the shutdown sequence.
６．２．２．
Checks before SVmco installation
This section describes the checks to make before SVmco installation.
Confirming PSA-to-MMB communication LAN settings
Confirming the services required for SVmco operation
