MMB CLI (Command Line Interface) Operations
2.2 Setting Commands
426
CA92344-0539-04
2.2.67 start raid copyback
Starts copyback to the specificed disk.
Privilege: Administrator, Operator, Partition Operator (Only managed partition)
(1) Input format
start raid copyback [SB | DU | IOU | PCI_BOX] <UNIT#>-<PCISLOT#> src=[<DISKSLOT#>
| < PORT#>-<CASCADE#>-<DISKSLOT#>] dist=[<DISKSLOT#> | < PORT#>-<CASCADE#>-
<DISKSLOT#>] {force}
(2) Option
src: This option specifies disk slot number which is a source of the copy. (ex. src=0) or port number and
cascade numbers and disk slot numbers for the external disks on disk enclosures which is a source of
the copy. (e.g. src=0-0-0).
dist: This option specifies disk slot number which is a destination of the copy. (ex. dist=0) or port number and
cascade numbers and disk slot numbers for the external disks on disk enclosures which is a destination
of the copy. (e.g. dist=0-0-0).
force: The command is executed without interactive operation with the user.
(3) Usage example
Example:When you start coyback from a disk attached to slot#0 to a disk attached to slot#1.
# start raid copyback SB 0-0 src=0 dist=1
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (CA92344-0540).
The command is executed successfully.
The operation is canceled
Too much arguments argc=%d.
Too few arguments argc=%d.
The specified parameter is invalid. %s
The specified controller is not found.
Port and cascade number is required in the parameter since more than 2 enclosures are connected.
Internal error [%d:%d].
The operation is failed. %s
Unable to execute the command because the %s is under maintenance.
Unable to process raid operation because you have not authority to access to the system assigned to the raid
controller.
Unable to process raid operation because you have not authority to access to the Partition#%d assigned to the
raid controller.
