A26361-K863-Z102-8-7619
Rev. 8.0
81
The Server Blade
Exchanging/Adding Procedures
8.5
Exchanging/Adding Procedures
8.5.1
Installing SDRAM/DDR RAM Modules
V
CAUTION!
Observe the safety information and the information on handling electro-
static-sensitive components in the section “Components With Electro-
static Sensitive Devices” on page 18.
The SDRAM/DDR RAM modules are equipped with coded connectors
so that they cannot be installed incorrectly.
V
CAUTION!
Use extreme care when removing an SDRAM/DDR RAM module. Apply
only enough pressure on the ejector levers to release the SDRAM
module.
Ê
Remove the server blade from the system (see “Removing the Server Blade”
on page 101).
Ê
Remove the SDRAM/DDR RAM module from its antistatic package.
I
Mounting/removing SDRAM or DDR RAM module occurs in the same
way. The following steps describe the procedure for the SDRAM.
