154
Chapter 5 Operations after OS Installation
Notes
When using the Teaming function, note the following points.
• For AFT/ALB/Static link/Dynamic link type, up to four LAN ports can be incorporated into one team
and two ports for a SFT type team.
• Once a Team is created, virtual adapters (Team:(Team Name)) will be created in the [Device
Manager] and [Network and Dial-up Connections] of the system. Do not disable or delete this virtual
adapter from the [Device Manager] or [Network and Dial-up Connections]. When deleting a virtual
adapter, make sure to use "Intel
®
PROSet".
• When the Teaming function is being used, only the following protocols can be used:
• For AFT/SFT/Static link/Dynamic link type: IP, NetBEUI, IPX (NCP), IPX (NetBIOS)
• For ALB type: IP, IPX (NCP)
• When the Teaming function is being used, Windows Load Balancing Service (WLBS) and Network
Load Balancing (NLB) cannot be used.
• If Static link type is selected, only the switch for link aggregation can be used.
• When adding/deleting a Static link type member, perform such operation in a linked down state.
Only a link down error between a LAN card (onboard LAN) and the switch it connects with, and the
equivalent errors lead to switching of the route. Therefore, if only the switch or LAN card (onboard
LAN) is partially damaged and the route being used is normal at the link level, the route will not be
switched in the team, but the communication using team may become an error.
For Windows Server 2008
Creating a team
1
Click [Start] – [Administrative Tools] – [Computer Management] to start Intel
®
PROSet.
2
Click [Network adapters] under [Device Manager] and double-click a LAN
adapter to be incorporated in a team.
3
Click the [Teaming] tab, select [Team with other adapters] and click [New
Team].
4
Enter a team name and click [Next].
5
Check the only LAN adapter to be incorporated in the Team and click [Next].
6
Select a Teaming type with which a Team will be created, and click [Next].
Select the following depending on the Teaming type:
• AFT type: "Adapter fault tolerance"
• ALB type: "Adaptive load balancing"
• SFT type: "Switch fault tolerance"
• Static link type: "Static link aggregation"
Summary of Contents for PRIMERGY BX620 S4
