88
Upgrade and Maintenance Manual
BX924
S3
Basic software procedures
I
Observe the following note when you use the ServerView Operation
Manager (SVOM) to administrate the server blade:
After replacing a Ethernet or Fibre Channel mezzanine card proceed as
follows:
Ê
Enter the SVOM
System Status – Network – Network Adapters –
Monitored Components
menu.
Ê
Click the
Acknowledge
button for the replaced mezzanine card.
The status of the component will then be set to
ok
. To see the new status
you must refresh the
Driver Monitor
view with
Refresh
.
5.2.5
Enabling Option ROM scan
In order to configure a mezzanine card that has been installed or replaced, the
card’s Option ROM has to be enabled in the system board BIOS. The card’s
firmware is called by the system BIOS upon reboot and can be entered and
configured.
Option ROM can be enabled permanently (e.g. in case of a boot controller that
may require frequent setup) or temporarily for one-time configuration.
I
For SAN / iSCSI boot the card's Option ROM has to be enabled
permanently.
When permanently enabling a controllers’s Option ROM, keep in mind that only
two Option ROMs can be activated in the system board BIOS at a time.
Ê
Open a virtual console for your server blade as described in section
"Launching a video redirection to a server blade" on page 69
.
Ê
Switch on or restart your server blade.
Ê
As soon as the startup screen appears, press the
[F2]
function key to enter
the BIOS.
Ê
From the
Advanced
menu select
Option ROM Configuration
.
I
When iSCSI is used via an onboard CNA, from the
Advanced
menu
select
Onboard Devices Configuration
-
Onboard CNA OpROM
.
Ê
Identify the desired mezzanine card slot and set its
Launch Slot # OpROM
setting to
Enabled.
Ê
Save your changes and exit the BIOS.
Summary of Contents for PRIMERGY BX924 S3
