Econel 100
Operating Manual
7
Introduction
Features
1.2
Features
System board
The features of the system board can be found in the technical manual of the
system board D2179 for the hardware and in the
BIOS Setup
for the firmware
(see
“Bibliography” on page 55
).
Hard disk drives
Up to four SATA hard disk drives, each with a maximum height of 1 inch, are built
into the drive rack. There is a wire connection to the controller.
Onboard SATA RAID controller
A SATA RAID controller is integrated on the system board; up to four SATA hard
disk drives can be connected to the controller. RAID levels 0, 1 and 10 are
supported for each LSI SATA software RAID.
I
The controller has its own configuration utility. More detailed information
may be found in the “LSI SATA Software RAID User’s Guide” manual (on
the
ServerBooks
CD under “Controller”).
Accessible drives
The first (top) bay contains the server's DVD drive. The fourth (bottom) bay can
be used for a 3.5" disk drive (1.44 Mbyte).
The two middle 5.25" bays are available for additional usable drives (CD/DVD
drives or a magnetic tape drive).
The accessible drives cannot be replaced during operation.
Power supply
The server has a built-in power supply unit, which automatically sets itself to a
mains voltage in the range of 100 V - 240 V.
High level of availability and reliability
When memory data is accessed, 1-bit errors in the main memory are recog-
nized and automatically corrected with the ECC (Error Correcting Code)
method.
