U41147-J-Z156-2-76
111
Appendix
Upgrading external SCSI interface
Figure 56: Mounting the external SCSI interface connector
Ê
Push the delivered SCSI interface connector into the opening prepared for
this purpose (1), and fasten it with two screws from the outside to the back
of the server.
Ê
Connect the free SCSI channel of the onboard LVD/U3W SCSI controller on
the system board (SCSI B) to the newly mounted external SCSI connector
by using the delivered cable. Refer to the documentation for the system
board for assistance.
Ê
Remount all housing components, and close the server as described in
chapter “Opening and closing the server” on page 47.
1
Summary of Contents for PRIMERGY H200
