U41147-J-Z156-2-76
85
System components and expansions
Memory extension
Ê
Swivel the handle downward to lock the processor module (2).
Ê
Close the server again (see chapter “Opening and closing the server” on
page 47).
Removing is done in the reverse order.
8.6
Memory extension
Ê
Shut down the operating system.
Ê
Switch off the server, and pull the power plug out of the power outlet.
V
CAUTION!
The power switch does not disconnect the device from the line
voltage. To disconnect the line voltage completely, remove the power
plug from the grounded power outlet.
Ê
Open the server (floorstand model only), and remove the housing and slot
cover (see chapter “Opening and closing the server” on page 47).
Figure 40: Removing the cover of the ventilation system
Ê
Remove the knurled screw (1), push back the ventilation system cover (2),
and remove it upward (3).
Ê
Expand the memory as requested. You will find the description for the
memory extension in the documentation for the system board.
1
3
2
Summary of Contents for PRIMERGY H200
