30
Chapter 1 Overview
2
Turn the handle in the direction of the arrow and pull it forward.
Unless you are inserting/removing media or turning the power on/off, keep the rack door closed. Doing
so blocks electric waves from cell phones, etc.
Do not lose the keys. If the key is lost, contact an office listed in the "Contact Information" of "Start
Guide".
1.4.2 Turning On the Server
1
Open the rack door.
2
Make sure that the floppy disk drive and CD-ROM drives are empty.
• Do not move, strike, or shake the server when it is turned on. This can damage
the hard disk in the server and cause data loss.
• Turn the server on when the temperature is in its operating environment range
(10–35°C). For details on the operating environment, refer to "Start Guide" and
"Safety Precautions".
When operating the device outside of this operating environment, the server
may operate improperly, damage data etc.
Furthermore, Fujitsu cannot be held responsible for any related damage,
malfunction, or loss of data, etc.
• The fans rotate at high speed immediately after the server is turned on, but this
is not defective. When the temperature is in the server's operating environment
range (10–35°C), they start to rotate at normal speed later.
• Be sure to wait for 10 seconds or longer after shutdown before turning the
server on.
Turn and then pull
Summary of Contents for Primergy RX100 S2
