RX2540 M2
Upgrade and Maintenance Manual
335
Expansion cards and backup units
8.8.2.5
Software configuration
If no DynamicLoM module was installed in the system before, proceed the
following steps:
Ê
Start
BIOS Configuration Utility
.
Ê
Press the
[F2]
key during POST phase.
Ê
Select
Advanced Menu
.
Ê
Select
Onboard Devices Configuration
.
Onboard CNA Enabled
Onboard CNA Oprom Enabled
Ê
In the
Save & Exit
menu select the required parameter and press the
[Enter]
key.
Ê
Start
Emulex PXESelect Utility
and confirm network settings. The
configuration of network settings should be performed by the customer.
Ê
Press the
[Ctrl]
+
[P]
keys during POST phase.
Ê
Press the
[F6]
key to continue.
Ê
Perform all necessary configuration entries for all ports.
Ê
Press the
[ESC]
key twice to get back to the
Port Selection Menu
.
Ê
Press the
[F7]
key to save the settings.
Ê
Press the
[Y]
key to exit the Utility menu.
Ê
Configure the new MAC address in the operating system, if you have no
VIOM (ServerView Virtual-IO Manager) installed.
If you have VIOM installed, it is not necessary to configure the MAC address.
This is virtualized by VIOM.
Ê
Only for D3245 with connection to SAN (Storage Area Network):
Ê
Update the SAN Zoning, because the WWPN (World Wide Port Name)
address has been changed.
Summary of Contents for PRIMERGY RX2540 M2
