RX2540 M4
Upgrade and Maintenance Manual
115
Basic software procedures
5.2.16 Looking for MAC/WWN/GUID and SAS addresses
The customer needs to know the new address of the controller:
– When replacing the system board with an onboard LAN controller
– When adding or replacing a network controller
– When adding or replacing a SAS controller
Different controllers send different addresses:
– LAN controller: MAC (Media Access Control) address
– Fibre channel controller: WWN (World Wide Name) address
– Infiniband/Omni-Path controller: GUID (Globally Unique IDentifier) address
– SAS controller: SAS (Serial Attached SCSI) address
5.2.16.1 Looking for the MAC address of a LAN controller
There are several possible locations where these addresses can be found.
Ê
Inform the customer about the new or changed MAC address.
Checking the label
Ê
If available, check the label on the controller.
Beside the part number, you may find the MAC address.
Using an UEFI BIOS
Ê
Enter the BIOS setup menu.
Ê
Select the
Advanced
menu.
The addresses are displayed at the
Advanced
menu main page.
I
Only network controllers supporting the Command Line Protocol
(CLP) will be displayed.
LAN controller provide the MAC addresses independent on Legacy
Boot or UEFI Boot.
Using the iRMC web interface
Ê
Log into the ServerView iRMC web interface.
Ê
Open the
System
menu.
Ê
Open the
Network
page.
Summary of Contents for PRIMERGY RX2540 M4
