276
Chapter 9 Operation and Maintenance
●
Administrator Password
This is the password that only allows the administrator to set up this server. Unless the set password is
entered, the BIOS Setup Utility cannot be used.
●
User Password
The password required to use the server. Unless the set password is entered, the OS cannot be booted.
To restrict OS booting, set [Password on boot] to [Enabled] in the [Security] menu of the BIOS Setup
Utility.
■
Setting a Password
The password is set in the BIOS Setup Utility. For details on the BIOS Setup Utility, refer to "8.3 BIOS
1
Start the BIOS Setup Utility.
"8.3.1 Starting and Exiting the BIOS Setup Utility" (Pg.237)
2
Select the [Security] menu and select the type of password to set.
• For the administrator password, select [Set Administrator Password] and press the [Enter] key.
• For the user password, move the cursor to [Set User Password] and press the [Enter] key. You
need to set [Set Administrator Password] in advance.
3
When the password input window is displayed, enter the password to set.
To delete the password, delete the displayed password.
4
Enter the password again to confirm it and press the [Enter] key.
5
Press the [Enter] key.
This sets the password.
■
Changing/Deleting Passwords
If a password is already set, perform the above password setting operations to display the password
changing or deleting window.
1
Enter the current password in the password input window.
2
Enter the new password and press the [Enter] key.
To delete the password, press the [Enter] key without entering anything.
3
Enter the password again to confirm it and press the [Enter] key.
To delete the password, press the [Enter] key without entering anything.
Summary of Contents for Primergy RX600 S2
