92
U41662-J-Z156-1-76
PCI boards
Hot-plug Components
Removing the PCI Board from the Pull-out Aid
V
CAUTION!
When removing the PCI board from the pull-out aid, pay special attention
to the snap-fits holding it attached to the pull-out aid (see
figure 34 on
page 92
). Do not lift them more than approx. 1 mm, i. e. only wide enough
to have the PCI board released. Otherwise the snap-fits could be
damaged.
Figure 34: Removing the PCI board from the pull-out aid
Ê
Lift the green movable snap-fits, but not more than approx. 1 mm (1), until
the PCI board is released completely.
Ê
Take the PCI board off (2), and put it aside.
1
2
1
1