U41662-J-Z156-1-76
95
Hot-plug Components
PCI boards
Removing the Supporting Plate from the Pull-out Aid
Figure 36: Removing the supporting plate from the pull-out aid
V
CAUTION!
When removing the PCI board from the pull-out aid, pay special attention
to the snap-fits holding it attached to the pull-out aid (see
figure 34 on
page 92
). Do not lift them more than approx. 1 mm, i. e. only wide enough
to have the PCI board released. Otherwise the snap-fits could be
damaged.
Ê
Lift the green movable snap-fits, but not more than approx. 1 mm (1) until the
PCI board is released completely.
Ê
Take the supporting plate off (2), and put it aside.
I
Keep the supporting plate for future use.
Ê
Slide the green snap-fits downwards until they are released from the pull-out
aid (see
figure 35 on page 93
) and keep them.
2
1
1