TX1320 M1
Upgrade and Maintenance Manual
165
System fan and HDD fan
8.2.2
Replacing the HDD fan module for 2.5-inch version
Figure 72: Position of the additional air duct
8.2.2.1
Required tools
●
Preliminary and concluding steps: tool-less
●
Replacing the fan module: tool-less
8.2.2.2
Preliminary steps
Before replacing the HDD fan module, perform the following steps:
Ê
Locate the defective server as described in section
"Locating the defective
server" on page 44
.
Ê
Shut down the defective server as described in section
"Shutting down the
server" on page 52
.
Ê
Disconnect the AC power cord from the system.
Ê
Remove the server cover as described in section
"Opening the server" on
page 55
.
Ê
Open the front cage as described in section
"Opening the front cage" on
page 60
.
Summary of Contents for PRIMERGY TX1320 M1
