TX140 S2
Upgrade and Maintenance Manual
197
Expansion cards and backup units
V
CAUTION!
Make sure that the connector side with the three dots is on the top (see
close-up). Otherwise you risk short-circuits.
9.5.3.3
Installing the BBU in the holder
Figure 116: Installing the BBU in the BBU holder
Ê
At a slight angle, fit the BBU under the right retaining bracket on the BBU
holder (1).
Ê
Fold down the BBU until it locks in place (2).
9.5.3.4
Installing the BBU holder into the chassis
Ê
Install the BBU holder into the chassis as described in section
"Installing the
FBU holder into the chassis" on page 193
.
9.5.3.5
Connecting the BBU cable to a controller
Ê
If applicable, install a RAID controller as described in section
"Installing
expansion cards" on page 176
.
Ê
Connect the BBU cable to the RAID controller.
Summary of Contents for PRIMERGY TX140 S2
