TX140 S2
Upgrade and Maintenance Manual
227
Processors
11.2.7 Concluding steps
Ê
"Installing the fan module" on page 152
Ê
"Reassembling" on page 58
Ê
"Connecting the server to the mains" on page 67
Ê
"Switching on the server" on page 68
Ê
If applicable,
"Updating or recovering the system board BIOS and iRMC" on
page 75
Ê
"Enabling SVOM boot watchdog functionality" on page 85
Ê
"Enabling BitLocker functionality" on page 90
11.3
Replacing the processor heat sink
11.3.1 Preliminary steps
Ê
"Locating the defective server" on page 43
Ê
"Shutting down the server" on page 46
Ê
"Getting access to the component" on page 47
Ê
"Removing the fan module" on page 151
11.3.2 Replacing the processor heat sink
Ê
Remove the processor heat sink as described in section
"Removing the
processor heat sink" on page 219
.
Ê
Apply thermal paste to the processor surface as described in section
"Applying thermal paste" on page 223
.
Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Tools:
Phillips PH2 / (+) No. 2 screw driver
Summary of Contents for PRIMERGY TX140 S2
