72
Operating Manual
TX150
S5
Switching the Server On and Off
Starting Up and Operation
Switching the server OFF
The power on indicator lights up green (item 2 in Figure
Ê
Shut down the operating system properly.
The server is switched off automatically and goes into standby mode. The
power on indicator lights up orange.
I
If the server does not switch off immediately, hold the On/Off button down
for at least four seconds or send a corresponding control signal.
Other on/off options
In addition to the On/Off button, the server can be switched on and off in the
following ways:
–
Specified switch on time / switch off time
The
ServerView
program allows you to set a time at which the server is to be
automatically switched on or off.
–
Ring indicator
The server is switched on by an internal or external modem.
–
Wakeup on LAN (WOL)
The server is switched on by a command from the LAN.
–
After power failure
The server is automatically switched on following a power failure (depending
on the BIOS settings).
–
“Power override” function
The server can be switched off immediately by pressing and holding the
On/Off button (approx. 4-5 sec.).
V
CAUTION!
There is a risk that data may be lost.
–
IPMI
The server is switched on from an IPMI console (via the COM1 serial
interface or the RJ45 LAN interface).