Chapter 3 Setting Configuration Information
The following example shows the current settings of a PW008GE5 card installed in
a PRIMEPOWER600.
{6} ok cd /pci@11,4000/FJSV,pgtb@5
{6} ok .properties
duplex half <--*1
transfer-speed 0000000a <--*2
cabinet-name Cabinet#0
board-name Motherboard#1
assigned-addresses 83002810 00000000 00100000 00000000 00010000
82002830 00000000 00110000 00000000 00010000
local-mac-address 00 e0 00 a6 c5 0c
fjgiga-rev 000000c2
product-name FJSV,pgtb
device_type network
address-bits 00000030
max-frame-size 00004000
reg 00002800 00000000 00000000 00000000 00000000
03002810 00000000 00000000 00000000 00010000
model Broadcom,BCM5703C
compatible fjgi
name FJSV,pgtb
media-type 1000BASE-T
fcode-rom-offset 00000000
66mhz-capable
fast-back-to-back
devsel-speed 00000001
class-code 00020000
interrupts 00000001
max-latency 00000000
min-grant 00000040
subsystem-id 000011a1
subsystem-vendor-id 000010cf
revision-id 00000002
device-id 000011a1
vendor-id 000010cf
pcibus-name PCIBUS#G
component-name 01-PCI#5
fru PCI Slot(PCI#5 at Motherboard#1)
*1: Displayed only when half-duplex is set.
*2: Displayed only when transfer-speed is set to a specific value.
[10Mbps:0xa, 100Mbps:0x64, 1000Mbps:0x3e8]
Note: *1 and *2 are not displayed in a default configuration.
[Returning to Default FCode Settings]
● To return to default FCode settings, execute the following command from the ok prompt,
or power cycle the system.
ok reset-all
38
Summary of Contents for PW008GE4
