29
G e t t i n g S t a r t e d
Starting Your
LifeBook Notebook
POWER ON
Power/Suspend/Resume Button
The Power/Suspend/Resume button is used to turn on
your LifeBook notebook from its off state. Once you
have connected your AC adapter or charged the internal
Lithium ion battery, you can power on your LifeBook
notebook.
(See figure 2-4 on page 6 for location)
To turn on your LifeBook notebook from its off state,
press the Power/Suspend/Resume button, located above
the keyboard. When you are done working you can
either leave your LifeBook notebook in Suspend mode,
(See Suspend Mode on page 32 for more information)
, or
you can turn it off
(See Power Off on page 33 for more
information)
.
When you power on your LifeBook, it will perform a
Power On Self Test (POST) to check the internal parts and
configuration for correct functionality. If a fault is found,
your LifeBook notebook will emit an audio warning and/
or an error message will be displayed.
(See Power On Self
Test Messages on page 64 for more information)
Depending on the nature of the problem, you may be able
to continue by starting the operating system or by
entering the BIOS setup utility and revising the settings.
After satisfactory completion of the POST, your note-
book will load the operating system.
BOOT SEQUENCE
The procedure for starting up your notebook is called
the Bootup sequence and involves your notebook’s Basic
Input-Output System (BIOS). When your LifeBook
notebook is first turned on, the main system memory is
empty, and it needs to find instructions to start up your
notebook. This information is in the BIOS program.
Each time you power up or restart your notebook, it
goes through a boot sequence which displays a Fujitsu
logo until your operating system is loaded. During
booting, your notebook is performing a standard boot
sequence including a POST. If the sequence is completed
without a failure and without a request for the BIOS
Setup Utility, the system displays the operating system’s
opening screen.
The boot sequence is executed when:
■
You turn on the power to your LifeBook notebook.
■
You restart your notebook from the Windows
Shut Down dialog box.
■
The software initiates a system restart. Example:
When you install a new application.
■
You reset the system by pressing the three keys
[CTRL+ALT+DEL].
BIOS SETUP UTILITY
The BIOS Setup Utility is a program that sets up the
operating environment for your LifeBook notebook.
Your BIOS is set at the factory for normal operating
conditions, therefore there is no need to set or change
the BIOS environment to operate your notebook.
The BIOS Setup Utility allows you to configure:
■
Device control feature parameters, such as changing
I/O addresses and boot devices.
■
System data security feature parameters, such as
passwords.
Entering the BIOS Setup Utility
To enter the BIOS Setup Utility do the following:
1. Turn on or restart your LifeBook notebook.
2. Press the [F2] key once the Fujitsu logo appears on
the screen with a prompt below it. This will open the
main menu of the BIOS Setup Utility with the
current settings displayed.
3. Press the arrow keys to scroll through the other
setup menus to review or alter the current settings.
Changing Video RAM Size
Your system is set up to use 16 MB of video RAM by
default, but you can change the allocated amount from
within the BIOS (up to 128 MB). To change the amount
of video RAM, perform the following steps:
1. Enter the BIOS Setup Utility as detailed above.
P O I N T
When you turn on your LifeBook notebook be sure you
have a power source. This means that at least one bat-
tery is installed and charged, or that the AC or Auto/
Airline adapter is connected and has power.
C A U T I O N
Do not carry your LifeBook notebook around with the
power on or subject it to shocks or vibration, as you risk
damaging your notebook.
P O I N T
Never turn off your LifeBook notebook during the
Power On Self Test or it will cause an error message to
be displayed when you turn your LifeBook notebook on
the next time.
(See Power On Self Test Messages on
page 64 for more information)
S Series.book Page 29 Thursday, September 25, 2003 1:13 PM
Summary of Contents for S2020 - LifeBook - Athlon XP-M 1.67 GHz
