Cleaning the Inside of the ScanSnap
425
4.
Connect the USB cable to the ScanSnap and the computer, then press
the [Scan/Stop] button for three seconds with the top cover open.
5.
Clean the feed roller and the eject roller with a cloth moistened with
Cleaner F1.
z
Feed roller (× 1)
Press the [Scan/Stop] button to rotate the roller. Gently wipe the dirt off while taking
care not to damage the surface of the roller. Make sure that it is cleaned properly
because residue on the roller will affect the feeding performance.
z
Eject roller (× 1)
Press the [Scan/Stop] button to rotate the roller. Gently wipe the dirt and dust off
while taking care not to damage the surface of the roller. Make sure that it is cleaned
properly because residue on the roller will affect the feeding performance.
If eject roller is difficult to clean, try cleaning it from the back while you keep the top
cover slightly open.
The USB cable should be connected to the computer only for cleaning the feed roller
and the eject roller.
z
Do not use water or mild detergent to clean the inside of the ScanSnap.
z
It may take a long time for Cleaner F1 to dry if an excessive amount is used. Moisten
the cloth with moderate quantity.
Wipe off the cleaner completely to leave no residue on the cleaned parts.
Pressing the [Scan/Stop] button seven times will rotate the feed roller and the eject roller
one revolution.
Eject roller ( × 1)
Feed roller ( × 1)
Eject roller ( × 1)
