delete existing ones, as well as copy definitions from one connection blade to
another.
In the upper left part of the
Graphic
tab there is the rear view of the selected
chassis. If an IBP is selected in this graphic, its uplink sets and networks are
shown in the table on the right. Additional information about the selected IBP
is shown on the left of the graphic. At the bottom of the tab there is a sche-
matic view of the uplink ports of the selected IBP.
If the selected IBP belongs to a switch stack, all members of this stack are
highlighted by coloring them (yellow for the stack master, green for other
stack members). In the port area, the uplink ports of all stack members are
displayed.
Figure 27: Graphic tab on the Ext. LAN Connections tab
New
Click
New
to define a new uplink set. The
Create network
wizard is
launched.
ServerView Virtual-IO Manager
149
5.3 Tabs
Summary of Contents for ServerView Virtual-IO Manager V3.1
