5 Virtual-IO Manager user interface
Active
Only available if the port is configured as
Backup
.
The corresponding port is configured as active and no longer as
backup.
Backup
Only available if the port is configured as
Active
.
The corresponding port is configured as a backup port and no longer
as active port.
Ports configured as active or backup ports are indicated by different col-
ors in the display (light red/light green or dark red/dark green). The name
of the uplink set is assigned to configured ports, which you can rec-
ognize by this.
With PY CB Eth Switch/IBP 1Gb 36/8+2 connection blades,
1GB uplinks and 10 Gb uplinks must not be mixed. If you try
this, the
Next
and
Finish
buttons will not be enabled.
The
Next
and
Finish
buttons are disabled while not at least one
active port is included in the uplink set.
5.4.1.5 DCB Properties step (Create Network wizard - single/VLAN network)
DCB Properties
is the third step in the
Create Network
wizard if a single
network or a VLAN network is created.
This step is only displayed if the connection blade supports DCB
(Data Center Bridging), i.e. for PY CB Eth Switch/IBP 10 Gb 18/8
connection blades.
172
ServerView Virtual-IO Manager
Summary of Contents for ServerView Virtual-IO Manager V3.1
