Fujitsu ST4120P User Manual Download

Page: 34 / 77

F u j i t s u S t y l i s t i c S T 4 1 2 0 P / 2 1 P Ta b l e t P C U s e r ’s G u i d e - S e c t i o n O n e

Replacing the Pen

With use, the pen tip may become worn or may
pick up foreign particles that can scratch the
screen. A damaged or worn tip may not move
freely, causing unpredictable results when
using the pen. If your pen exhibits these
problems, contact your reseller to purchase
replacements.

USING HOVERING MODE

Selecting the Pen Hovering application button
on the Fujitsu Stylistic ST4120P/21P Tablet PC
provides you with better cursor control. When
the hovering option is enabled, the cursor can
be positioned over an icon without activating it.
The is useful when you are performing
procedures that require accurate cursor
positioning, such as when simulating mouse
rollover, selecting a small icon, or beginning a
paint session.

• To enable hovering, press the Function

button

and the Right-Click button

at the same time.

• To disable hovering, press the Function

button

and the Right-Click button

again.

For help on Normal/Special Hover mode
settings in the Pen Configuration applet, press
[F1] to invoke help from within the applet.

CHARGING THE BATTERY

The Fujitsu Stylistic ST4120P/21P Tablet
battery can be charged while it is installed in
the Pen Tablet PC.

To do so:

1. Connect a DC power source, such as the AC

adapter, to the DC input connector on the
Pen Tablet PC. The DC Input icon appears in
the Status display. If the battery charge is
below 90%, the battery begins charging and
the Charging icon appears in the Status
display. If the battery charge is 90% or
higher when you connect DC power, the
battery will not charge, preventing battery
overcharging.

Approximate

Charge Time

(not in use)

3.5 hours

4.5 hours

Approximate

Charge Time

(in use)

7 hours*

8 hours

Table 2-3 Battery Charging Time

Battery Charge

Level Reached

90%

100%

2. Look at the Battery Gauge icon in the Status

display to determine the percent of charge in
the battery. See “Status Display” in Chapter
1 of this manual for a description of the
Battery Gauge icon.

As long as DC power remains connected to the
Pen Tablet PC, the charging process continues
until the battery charge reaches 100%. Charge
times shown in Table 2-3, “Battery Charging
Time" are for a fully discharged battery
charging both while the Pen Tablet PC is and is
not in use.

Also note the following with respect to charging
the battery:

• You can use the system, suspend system

operation, or shut down and turn off the
system without interrupting the charging
process; however, using the system while
the battery is charging will cause the battery
to charge at a slower rate, as noted in Table
2-3, “Battery Charging Time".

• As noted in the procedure above, the system

will not begin charging the battery if the
battery charge level is 90% or higher when
the system is initially connected to external
DC power. (This prevents the battery from
being overcharged.)

• The Fujitsu Stylistic ST4120P/21P Tablet

battery uses Lithium ion battery cells which
have no “memory effect.” You do not need to
discharge the battery before you begin
charging.

Alb Passive 2(17-28)

25/3/03, 11:54 AM