XG Series User's Guide
Chapter 5 Command Reference
Port Information Settings
153
5.1.10
ether output rate control information
This section explains about the commands related to ether output rate control information.
5.1.10.1 ether ratecontrol
Function
Set output rate limit of ether port
Available Model
XG2600
Syntax
ether <number> ratecontrol <rate>
Options
<number>
•
ether port number
Set a port number to use with a decimal value.
When setting multiple port numbers, separate them with commas (,).
When setting sequential numbers, separate them with hyphens (-). (Example: "1-8")
<rate>
•
Output rate
Specify output rate which is limited in the ether port with Mbps or Gbps
40m to 10000m
1g to 10g
If "10000m" or "10g" is set, packets are not limited.
Use Mode
Configuration mode (admin class)
Explanation
Set output rate control.
Caution
"ether qos mode drr" command and
command can not use at the
same time and same port.
Default
It is assumed that the output rate limit function is not used.
