XG700 User's Guide
102/266
All Rights Reserved, Copyright (C) PFU LIMITED 2005-2006
5.7 Link Aggregation Configuration Commands
This section explains the commands required in using link aggregation.
5.7.1 show link-aggregation
Function
Displays the state of an aggregation group.
Prompt
xg> or xg#
Command syntax
show link-aggregation [ agg-port <1-6> ]
Parameter
agg-port <1-6>
Specifies the aggregation group number. The value can be set in the range of 1 to 6.
When this parameter is omitted, the state of all aggregation groups will be displayed.
Command type
Operation management commands
Output form (in case of static link aggregation)
xg# show link-aggregation
Link Aggregation Information 2005/08/22-14:30:35
===============================================================================
System Priority : 32768
System ID
: 0080.17c2.2144
-------------------------------------------------------------------------------
[agg-port 1]
Master port
: port <1-12>
Management packet send port : port <1-12>
Mac address
: 0080.17c2.2144
Protocol : None
Distribution algorithm : { Destination address | Source address
| Destination address & Source address}
Distribution parameter
: <0-3>
The minimum number of ports : 1
[port 1]
Port Status : {Active | Inactive }
[port 2]
Port Status : {Active | Inactive }
-------------------------------------------------------------------------------
[agg-port 2]
================================================================================
Link aggregation common information
Link aggregation information related to the switch in general will be displayed.
System Priority
The system priority used in LACP is displayed.
System ID
The identification information used in LACP is displayed.
The setting state of each aggregation group will be displayed.
[agg-port 1]
Indicates the aggregation group number to display.
Master port
Displays the master port number of the aggregation group.
Of the ports consisting of a link aggregation, the one with the smallest port number will be the master port.
Management packet send port
The port number, which transmits control protocol between switches such as BPDU and IGMP, is displayed.
Normally, of the ports consisting of an aggregation group, the one with the smallest port number among the ports in link
up state will be the management packet send port.
Mac address
Displays the MAC address of the aggregation group. This MAC address will be the same value as that of the master
port.
