XG700 User's Guide
115/266
All Rights Reserved, Copyright (C) PFU LIMITED 2005-2006
Filter Information
Ingress Filter (no vlan member)
The state of ingress filtering by VLAN ID is displayed.
−
Disabled
The ingress filtering by VLAN ID is disabled.
−
Enabled
The ingress filtering by VLAN ID is enabled.
Discards frames of VLAN ID not belonging to VLAN member, when they are received.
Ingress Filter (tagged frame)
The state of ingress filtering of a tagged frame is displayed.
−
Disabled
The ingress filtering of a tagged frame is disabled.
−
Enabled
The ingress filtering of a tagged frame is enabled.
Discards tagged frames when they are received.
Ingress Filter (untagged frame)
The state of ingress filtering of an untagged frame is displayed.
−
Disabled
The ingress filtering of an untagged frame is disabled.
−
Enabled
The ingress filtering of a tagged frame is enabled.
Discards untagged frames when they are received.
Link Signal Tune Information
Adjustment
Displays the internal parameter used for Rx signal optimization.
−
Auto
Indicates the internal parameter being automatically selected based on the Rx signal from the partner device.
−
Short
Indicates that the internal parameter for when the 10GBASE-CX4 connection cable is short is set.
−
Long
Indicates that the internal parameter for when the 10GBASE-CX4 connection cable is long is set.
Mode
Displays the timing at which Rx signal optimization is performed.
−
Auto
Indicates that Rx signal optimization is automatically performed everytime a new signal is detected from the
partner device.
−
Hold
Indicates that the optimized state of a reception signal that was firstly optimized when detected is being
retained. After the first optimization, optimization is not performed again.
Example
Display the state of the switch port 3.
xg> show interface port 3