XG700 User's Guide
119/266
All Rights Reserved, Copyright (C) PFU LIMITED 2005-2006
5.9.6 storm-control
Function
Enables broadcast storm control for the ports.
Use the no form to disable storm control.
Prompt
xg(config-if)#, or xg(config-agg)#
Command syntax
storm-control
no storm-control
Command type
Configuration command
Default
None
Note
When storm state is detected, the port will be in violation state. After eliminating the cause of the storm state, clear the
violation state with the "clear violation" command.
Example
Enable the storm control for Port 3 of the switch.
xg(config)# interface port 3
xg(config-if)# storm-control
5.9.7 suppress-address-learning
Function
Disables the dynamic learning of the MAC address table for switch ports.
Use the no form to enable learning.
Prompt
xg(config-if)#, or xg(config-agg)#
Command syntax
suppress-address-learning
no suppress-address-learning
Command type
Configuration command
Default
None
Example
Disable the dynamic learning of the MAC address table.
xg(config-if)# suppress-address-learning