XG700 User's Guide
123/266
All Rights Reserved, Copyright (C) PFU LIMITED 2005-2006
5.9.12 ingress-bandwidth
Function
Sets ingress rate limiting value of ports.
When reception traffic exceeds the ingress rate limiting value, received frames will be discarded.
Use the no form to return to the default setup.
Prompt
xg(config)# , or xg(config-agg)#
Command syntax
ingress-bandwidth <40-10000>
no ingress-bandwidth
Parameter
<40-10000>
Specifies the ingress rate limiting value in the range of 40 to 10000. The unit is Mbps. The value must be an integer
multiplied by 40.
For an aggregation group, specifies the ingress rate limiting value to set to each port comprising the aggregation group.
The total ingress rate limiting value as the aggregation group will be the specified ingress rate limiting value multiplied
by the number of ports.
Command type
Configuration command
Default
10000
Message
% The set value is not step of 40.
Explanation
The specified ingress rate limiting value is not an integer multiplied by 40.
Solution
Specify the ingress rate limiting value with an integer multiplied by 40.
Note
If the set ingress rate limiting value x, the actual ingress rate limiting value will be expressed in the approximation
below.
Actual ingress rate limiting value = {integral part of (rate 256 / 10000)} 10000 / 256
Measurement of the ingress rate is performed in the unit of 100
µ
s. Therefore, when burst transfer is performed in time
unit exceeding 100
µ
s, the actually permitted ingress rate may be smaller than the specified value.
Example
Set the ingress rate of port 3 to 5Gbps.
xg(config)# interface port 3
xg(config-if)# ingress-bandwidth 5000