XG700 User's Guide
171/266
All Rights Reserved, Copyright (C) PFU LIMITED 2005-2006
5.15.2 monitor traffic-counts
Function
Displays the transmission frame count at each port.
Prompt
xg> or xg#
Command syntax
monitor traffic-counts { current | total } [interval <3-60>]
Parameter
{ current | total }
Specifies the statistics to be displayed.
−
current
Displays the number of cumulative transmission frames after startup of this command.
−
total
Displays the number of cumulative transmission frames after startup of the system.
interval <3-60>
Specifies the statistics updating interval (in seconds).
The default interval is 3 seconds.
Command type
Operation management command
Output format (if "current" is specified)
xg# monitor traffic-counts current
Traffic Statistics(Current Frame Counts) 2005/08/22-12:12:15
========================================================================================
Port Link State/ Tx-Frame Rx-Frame
Tx-Frame
Rx-Frame Rx-Bcast
Rx-Mcast
STP State Counts/S Counts/S Counts Counts
Counts Counts
---- ---------- ---------- ---------- ---------- ------------ ----------- -----------
1 Up/Discard 12345678K 12345678K 1234567890K 1234567890K 1234567890K 1234567890K
2 Down 0
0 0
0 0 0
3 Up/Discard
923 923 1234567890K 1234567890K 1234567890K 1234567890K
4 Up/Learn
999123 999123
1234567890M
256M
256M
256M
5 Up/Forward
999 999 1234567890G
256G
256G
256G
6 Up/Forward
999999 999999
1234567890T
256T
256T
256T
Port
Displays port numbers. Statistics of each port are displayed on a line.
Link State/STP State
Displays the port state in the Link State or STP State format.
The Link State may indicate one of the following link states.
−
Down
The port link is down.
−
Up
The port link is up.
The STP State displays the current port status based on the STP (Spanning Tree Protocol). Note that the STP State is
not displayed if the Link State is Down.
For port status details, see “
Spanning Tree Protocol Port States
”.
Tx-Frame Counts/S
Displays the transmission frame rate (in fps) using an 8-digit, right-justified value.
Rx-Frame Counts/S
Displays the receive frame rate (in fps) using an 8-digit, right-justified value.
Tx-Frame Counts
Displays the number of cumulative transmission frames after execution of this command, using a 10-digit, right-justified
value.
Rx-Frame Counts
Displays the number of cumulative receive frames after execution of this command, using a 10-digit, right-justified
value.
Rx-Bcast Counts
Displays the number of cumulative receive broadcast frames after execution of this command, using a 10-digit,
right-justified value.
Rx-Mcast Counts
Displays the number of cumulative receive multicast frames after execution of this command, using a 10-digit,
right-justified value.