XG700 User's Guide
179/266
All Rights Reserved, Copyright (C) PFU LIMITED 2005-2006
5.15.8 monitor dataflow
Function
Displays statistics including both pause frame transmission to/from each port and transmission processing.
Prompt
xg> or xg#
Command syntax
monitor dataflow { current | total } [interval <3-60>]
Parameter
{ current | total }
Specifies the statistics to be displayed.
−
current
Displays the cumulative data count after startup of this command.
−
total
Displays the cumulative data count after the system startup.
interval <3-60>
Specifies the statistics updating interval (in seconds).
The default interval is 3 seconds.
Command type
Operation management command
Output format (if "current" is specified)
xg# monitor dataflow current
Dataflow Statistics(Current Counts) 2005/08/22-12:12:15
==============================================================================================
Port Link State/
Flow-Ctl Forward Flood Rx-Pause Tx-Pause Full-Drop VLAN-Drop
STP State Mode Counts Counts Counts Counts Counts Counts
---- ------------- ------- ----------- ----------- ----------- ----------- ----------- -----------
1 Up/Discard Rx & Tx 1234567890 1234567890 1234567890 1234567890 1234567890 1234567890
2 Down
Rx
0 0
0 0 0
0
3 Up/Discard Rx & Tx 1234567890K 1234567890K 1234567890K 1234567890K 1234567890K 1234567890K
4 Up/Learn
Rx & Tx 1234567890M
25690M 25690M 25690M
25690M 25690M
5 Up/Forward Rx & Tx 1234567890G
25690G 25690G 25690G
25690G 25690G
6 Up/Forward Rx & Tx 1234567890T
25690T 25690T 25690T
25690T 25690T
7 Down Rx 0
0 0
0
0 0
8 Down Rx 0
0 0
0
0 0
==============================================================================================
ESC:exit F:refresh
U:page up D:page down L:page left R:page right
Port
Displays port numbers. Statistics of each port are displayed on a line.
Link State/STP State
Displays the port state in the Link State or STP State format.
The Link State may indicate one of the following link states.
−
Down
The port link is down.
−
Up
The port link is up.
The STP State indicates the current port status based on the STP (Spanning Tree Protocol). Note that the STP State is
not displayed if the Link State is "Down".
For port status details, see “
Spanning Tree Protocol Port States
”.
Flow-Ctl Mode
Displays the flow control setup of each port.
−
Rx & Tx
Both transmission and reception of pause frames are enabled.
−
Rx
Only the reception of pause frames is enabled.
Forward Counts
Displays the cumulative number of frames which have been forwarded normally (among the unicast frames received at
each port after the startup of this command).
Flood Counts
Displays the cumulative number of flooded frames among the unicast frames received at each port after the startup of
this command.
Rx-Pause Counts
Displays the cumulative number of pause frames which have been received at each port after the startup of this
command.
Tx-Pause Counts
Displays the cumulative number of pause frames which have been sent from each port after the startup of this
command.
Full-Drop Counts
Displays the number of frames which have been discarded due to the saturated input buffer of the system among those
received at each port after startup of this command.