XG700 User's Guide
67/266
All Rights Reserved, Copyright (C) PFU LIMITED 2005-2006
5.4 System Basic Operation Commands
This section explains the basic commands, which are necessary when using CLI operation of the XG700.
5.4.1 enable
Function
Switches from the operator exec mode to the administrator exec mode.
When a password is set to the "enable" command, entering the password is required. When there is an error in entering the
password, entering of the password will be prompted up to three times. Additionally, after successful authentication of the
password, and switching to the administrator exec mode, entering the password for the enable command will not be prompted
while logged in.
Prompt
xg>
Command syntax
enable
Command type
Operation management commands
Example
Switch from the operator exec mode to the administrator exec mode using the "enable" command.
The prompt character will change to "xg#."
xg> enable
xg#
When a password is set to the "enable" command, enter the password.
When password authentication is successful, it switches to the administrator exec mode, and the prompt character will change
to "xg#."
xg> enable
Password:
←
Enter the password to "enable."
xg#
(The entered password is not displayed.)
5.4.2 disable
Function
Switches from the administrator exec mode to the operator exec mode.
Prompt
xg#
Command syntax
disable
Command type
Operation management commands
Example
Switch from the administrator exec mode to the operator exec mode using the "disable" command.
The prompt character will change to "xg>."
xg# disable
xg>
