Procedure – switch ON; the FRE-207 then auto levels. Press the red "G"
button on the Remote Control or laser's keypad & the X illuminates on the
screen.
Press the X/Y button ONCE only to scroll down to a flashing "Y". Using the top
two right hand buttons, set the % value required.
The same buttons can be found on the Remote Control. Press X/Y button
ONCE again and the laser will adjust to this angle of slope, then rotate.
To return to Auto level, switch the laser OFF & ON again via the green button,
to reset the % values to zero. The Laser will wait to find true level, then
automatically restart, self levelled.
Setting both X & Y axis slope (dual grade) -
Proceed as above, but enter values for both X% & Y%
Automatic Drift System (ADS):
Operated via bottom, right-hand yellow button, showing a "picture of a tilted
instrument" and repeated on the Remote Control.
Once the FRE-207 is ON and rotating in the auto (self) levelled mode, the
automatic drift system can be activated. Press the button &
TILT
wil be
displayed on the screen.
ADS is now ON.
If the Laser is knocked or caught by a gust of wind for example, the laser
head will stop rotating and an audible alarm sound to warn the User of the
problem.
Check all is OK, press the ADS button again & the laser will reset back to
AUTO level.
IMPORTANT: The ADS function cannot be set when Grading.
Remote Control & Laser Detector:
4
