Remote Control...
Fit the supplied 2pc x AA alkaline batteries, taking care with correct polarity.
The Remote’s keypad can set the following functions:
1. Rotating speed in increments; slow for Indoors, fast (max) for Outdoors
2. Scan angles & position around the room.
3. ADS (see above)
4. Auto / Manual (grade) setting via the red "G" button.
5. X/Y button to set required grade axis, then +/- button to adjust the %
value.
In fact, it is often better to use the Remote Control rather than the
instrument's keypad, because then you do not disturb the laser's sensitive
mechanism.
Detector...
Fit the supplied 9V battery, polarity marked. Power up via red ON/OFF button.
The middle button switches the sounder ON or OFF, & volume - if required
The right hand button sets coarse (+/-2mm) or fine (+/-1mm) red pick-up
window resolution.
A rear LCD repeats the main front display.
Note case markings & setting notches.
You can use the detector with or without its staff mounting bracket.
Detector Procedure
– face towards rotating laser & "find" rotating laser
beam via the pick-up window.
If the sun is low in the sky & shining into the red window, shield it with a
5
