Fulbat Fulload 750, User Manual

 FULBAT - www.fulbat.com

3

Charge current

0,75A

Battery Capacity: charging

2-20Ah

Battery Capacity: maintaining

2-30Ah

ELECTRICAL PARTS

Delivered with:

•  Input: 50cm

•  Output: 150cm

•  Short cable with alligator: 30cm

•  Short cable with ring terminal: 30cm

ENVIRONMENTAL CHARACTERISTICS

•  Operating Temperature: 0 to 45°C

•  Storage Temperature: -25 to 85°C

•  Operating Humidity Range: 0 to 70% RH

•  Cooling: Passive/Natural

TECHNICAL SPECIFICATIONS

Part number

FULLOAD 750

Type

Automatic

Approvals

CE

Input voltage range

100-240V

Input frequency

50/60Hz

Output

0.75A @ 6/12V

Size (LxWxH) in mm

80x50x28

Weight

0.2Kg

CHARGING INSTRUCTIONS

STEP 1 - Pre charge check & electrolyte level check

•  Check the battery electrolyte level (not required on sealed & main-

tenance free batteries).

•  If necessary, remove the vent caps and add distilled water so the 

levels are halfway between the upper and lower fill lines.

•  Check the voltage output switch on the charger and make sure it’s 

on the correct voltage.

STEP 2 - Connecting the battery charger to your battery

•  If the battery is out of the vehicle:

•   Connect the red lead from the charger to the positive (+) battery 

terminal.

•  Connect the black lead from the charger to the negative (-) battery 

terminal.

BLACK

RED

•  If the battery is still in the vehicle, determine if the vehicle is positively 

(+) or negatively (-) earthed.

• 

If negatively earthed (most common) – first connect the red (+) 

battery charger lead to the positive (+) battery post and then connect 

the black (-) battery charger lead to the vehicle’s chassis and away 

from the fuel line.

BLACK

RED

•  If positively earthed – First connect the black (-) battery charger lead 

to the negative (-) battery post and then connect the red (+) battery 

charger lead to the vehicle’s chassis and far away from the fuel line.

RED

BLACK

STEP 3 - Connect the battery charger to mains power (240Vac)

•  Connect the battery charger to a 240VAC mains powered socket.

•  Turn on the 240VAC mains power.

•  The charger will automatically start when AC power is connected 

and switched on. (note: If the fault indicator LED illuminates red, 

please check your connections as it’s likely that the positive and 

negative Leads are reversed. Refer to trouble shooting page for 

further information).

STEP 4 - Disconnecting the battery charger from battery

•  If the battery is out of the vehicle.

-

Switch OFF and remove the AC power socket from the outlet.

-

Remove the black lead and then the red lead.

-

Check electrolyte levels if possible.

(As they may need topping up with distilled water after charging).

•  If the battery is in the vehicle.

-

Switch OFF and remove the AC power socket from the outlet.

-

Remove the lead from the vehicle chassis.

-

Remove the lead from the battery.