5/14/2018
Fuling Inverter User Manual - slidepdf.com
http://slidepdf.com/reader/full/fuling-inverter-user-manual
39/54
Response delay: means the interval t ime from the end of data receive to transmitting response dat a to
upper level machine. If response de lay time is smaller than system operation time, resp onse delay time
should be system operation time. If re sponse delay time is longer than system operation time, inverter can
not transmit data to upper level machine until response delay time reached.
When this parameter is set to be 0. 0s, this function is invalid.
When this function is valid, if the interval time between two communications exceeds communication
overtime time, it will cause communication fault (E018).
When this parameter is set to be 0, Response when write.
When this parameter is set to be 1, N o Response when write.This function can improve communiation
speed.
- 7 1 -
- 7 2 -
10-bits(forASCII)
bit1
bit0
bit2 b it3 bit4 bit5 bit6 bit7
Even
bit
Stop
bit
Start
bit
8-data bits
11-bits character frame
DATA Frame：8 E 1
bit1
bit0
bit2 b it3 bit4 bit5 bit6 bit7
Odd
bit
Stop
bit
Start
bit
8-data bits
11-bits character frame
DATA Frame：8-O-1
bit1
bit0
bit2 bit3 bit4 bit5 bit6
Stop
bit
Stop
bit
Start
bi t
7-data bits
10-bits character frame
DATA Frame：7-N-2
bit1
bit0
bit2 bit3 bit4 bit5 bit6
Stop
bit
Start
bi t
7-data bits
10-bits character frame
Even
bit
DATA Frame：7-E-1
bit1
bit0
bit2 bit3 bit4 bit5 bit6
Odd
bit
Stop
bit
Start
bi t
7-data bits
10-bits character frame
DATA Frame：7-O-1
F6.03
Communication
response delay
0 2 00 ms
～
5ms
Code
Name
g
g
Value
F6.04
Communication
overtime fault time
0 .0 i n va li d
0 .1 10 0. 0s
（
）， ～
0.0s
Function
Code
Name
Setting Range
Default
Value
F6.05
Communication
error measure
1
0 Alarm and free run stop
：
1 No alarm and keep running
：
2 No alarm and stop according to
stop mode(by communication)
：
3 No alarm and stop according to
stop mode(by all control mode)
：
Function
Code
Name
Setting Range
Default
Value
F6.06
Response
measure
0
0 Response when write
：
1 No response when write
：
Function
Code
Name
Setting Range
Default
Value
