15
KNOW YOUR PRODUCT
Driving fasteners
This tool has three firing methods:
Single fire, Sequential fire
and
Bump fire.
This allows for driving fasteners in different ways for precise accuracy or speed.
The tool will be fitted with a single sequential fire trigger from the box. If the user
wants to use bump fire, they must change the trigger. Refer to
"Fitting the bump
fire trigger"
on page 19 of this manual.
•
Single fire - fires one fastener only (fig. 6-7)
This method will fire one fastener only when the tool is pushed against the work
surface and each time the trigger is pressed, this is an accurate and more precise
method of firing fasteners.
1.
Grip the handle firmly.
2.
Press the safety striker on the material until it is compressed completely and
press the trigger to fire one fastener.
3.
To fire again; first remove the safety striker from the material.
Note:
Aways remove your finger from the trigger after the fastener is driven into
the workpiece.
4.
Repeat the procedure for the next fastener.
Fig. 6
Fig. 7
WARNING!
Do not operate the tool without fasteners in the magazine.
Remove finger from trigger when not firing fasteners.
OPERATION
WARNING!
Always wear eye protection. Make sure the eye protection
chosen has side shields or provides protection from flying debris both from
the front and sides.
