16
KNOW YOUR PRODUCT
• Bump fire - Fires one fastener only each time the safety striker hits the
material. Ensure the select fire switch is in the multiple firing position.
This method will fire a fastener with the trigger pressed as you bump the tool
along the workpiece making contact at the points where you want to insert the
fastener. This method is less accurate but is a much faster firing method.
1.
Grip the handle firmly.
2.
Press the trigger and then
bump the safety striker
on the material to fire a
fastener; each time the
safety striker hits the material
with the trigger pressed a
single fastener will fire (fig.
8).
OPERATION (cont.)
WARNING!
Do not clamp or hold the trigger with anything other then
your hand.
• Sequential fire - fires one fastener after the other when the trigger is
pressed.
This method will fire a fastener when the trigger is pressed as you drag the safety
striker along the work piece. This method is a much faster firing method.
1.
Grip the handle firmly.
2.
Press the safety striker on the material until it is compressed completely and
press the trigger to fire one fastener.
3.
To fire again; keep the safety striker pressed to the material and drag along the
material whilst pressing and releasing the trigger to fire.
Note:
Aways remove your finger from the trigger after the fastener is driven into
the work piece.
Fig. 8
WARNING!
Do not over reach. Keep proper footing and balance at all
times.
