8
AIR RATCHET WRENCH SAFETY WARNINGS
•
Read and understand instruction manual before using.
•
Always wear impact-resistant eye protection during the operation of the
air tool.
•
Do not use this product if it is not completely assembled or if any parts
appear to be missing or damaged.
Use of a product that is not properly and
completely assembled could result in serious personal injury.
•
Do not carry tool with finger on the trigger.
•
Disconnect the tool from the air supply before performing maintance
,
leaving work area, moving tool to another location, making any adjustments,
during non-operation or handing tool to another person. Failure to do so
could result in serious personal injury.
•
Clean and inspect the tool daily.
Carefully check for proper operation of
trigger and safety mechanism.
•
DO NOT use the tool unless the trigger is functional,
or if the tool is
leaking air or needs any other repair.
•
Be aware that the failure of the work piece,
or accessories, or even of the
air tool itself, can generate high-velocity projectiles.
•
Air under pressure can cause severe injury.
•
Whipping hoses can cause severe injury.
Always check for damaged or
loose hoses and fittings.
•
DO NOT exceed the maximum pressure stated on the tool.
•
Never carry an air tool by the hose.
•
Quick connector couplings shall be used for connection to the compressed air
system and non-sealable air inlet connector must be fitted at the tool in such
a way that no compressed air remains in the tool after disconnection.
•
Air tools shall only be connected to an air supply where the maximum
allowable pressure of the tool cannot be exceeded by more than 10%; in
the case of higher pressure ,a pressure reducing valve which includes a
downstream safety valve shall be built into the compressed air supply.
•
Check prior to each operation that the safety and triggering mechanism is
functioning properly and that all nuts and bolts are tight.
•
Do not carry out any alterations to the air tool.
•
Avoid weakening or damaging the tool, for example by:
– punching or engraving;
– modification not authorized by the manufacturer;
– guiding against templates made of hard material such as steel;
– dropping or pushing across the floor;
– applying excessive force of any kind..
WARNING!
Disconnect the tool from the air supply before inspecting the
air tool. Failure to do so could result in serious personal injury.
